The Malleus Machined Grips for Honda Shadow are the perfect choice for your bobber or chopper build! The throttle sleeve tube fits most throttle cables and stock Honda shadow switch housings and the clutch side grip and throttle sleeve tube will work with all 1" handlebars.
The Malleus Machined Aluminum Throttle Sleeve and Clutch Grip set is the most simple way to set up your handlebars, no need for grips that will wear out or need replacing! The throttle sleeve and clutch side grip are machined from 6061 Aluminum and anodized with beautiful knurling, not too extreme, just enough to provide a solid hold! I always hated when grips were knurled to the point of aggressively shredding my palms!! Not so with the Malleus Grip Set! The throttle sleeve fits perfectly in our Acerus Throttle Assembly
The matching clutch side grip simply slides on and attaches to the handlebar with 3 included #6-32 set screws, we recommend using a bit of red loc-tite on each screw . Some folks like to add a dab of glue when sliding the clutch side grip on, but we have found it's not necessary.
The throttle sleeve is meant for single cable operation. It is not meant to run the push cable. You do not need the push cable, remove it and enjoy your newfound throttle performance!!
Fits 1" handlebars
Fits the following models throttle cables -
Honda Shadow VLX600 / VT600
Honda Shadow VT750, ACE, Aero, Spirit, Phantom, RS
*May fit other metric bikes.
While this part doesn't need grips, you can leave the clutch side grip off and use a traditional set of rubber grips. A rubber grip set will fit over the throttle sleeve.
We recommend using a tiny bit of red thread-locker on the set screws of the clutch side grip.
This is for the purchase of the grips only. The video is for example purposes and shows other pieces which are not included