Kreem Fuel Tank Repair Kit - Complete 3-Step System for Motorcycle Gas Tanks
Complete Fuel Tank Restoration System
The Kreem Combo Kit is the industry-standard solution for repairing and sealing motorcycle fuel tanks. This comprehensive 3-step system removes rust, prepares the metal surface, and applies a durable protective liner to restore leaking or corroded tanks to like-new condition.
What's Included:
- Kreem Rust Remover - Dissolves rust and corrosion
- Metal Prep - Etches and prepares the tank surface
- Kreem Tank Liner - Seals and protects the interior
Technical Specifications
-
Coverage: Treats tanks up to 5 gallons (19 liters)
-
Cure Time: 96 hours (4 days) for full cure
-
Temperature Range: Apply at 70°F (21°C) or above for best results
-
Compatibility: Gasoline only - not for use with ethanol blends above E10
Step-by-Step Application Instructions
Step 1: Rust Removal (24 hours)
- Remove petcock, fuel cap, and all fittings from tank
- Pour Kreem Rust Remover into tank and seal all openings
- Rotate tank every few hours to ensure complete coverage
- Let sit for 24 hours, then drain and rinse thoroughly with water
- Dry completely using compressed air or heat gun
Step 2: Metal Prep (30 minutes)
- Pour Metal Prep solution into dried tank
- Rotate and agitate for 20-30 minutes to etch the metal surface
- Drain completely and rinse with water
- Dry immediately and thoroughly - moisture will cause liner failure
Step 3: Tank Liner Application (96 hours cure)
- Work in a well-ventilated area at 70°F or warmer
- Pour entire contents of Kreem Liner into tank
- Rotate tank slowly and continuously for 20-30 minutes, coating all interior surfaces
- Drain excess liner back into container (can be reused immediately)
- Remove tape from openings and allow fumes to escape
- Let tank sit upright for 4-6 hours, then rotate 90° every few hours
- Allow 96 hours (4 days) for complete cure before adding fuel
Important Safety & Application Notes
- Work in a well-ventilated area - fumes are strong
- Wear chemical-resistant gloves and eye protection
- Tank must be completely dry before applying liner - any moisture will cause failure
- Do not use with ethanol fuels above E10 (10% ethanol)
- Remove all old liner or sealant before starting
- Ambient temperature must be 70°F (21°C) or higher during application and cure
Best Results Tips
For tanks with heavy rust, you may need to repeat Step 1 or use mechanical cleaning first. Ensure absolute dryness before liner application - this is the most critical step. Plan for a full week without riding to allow proper cure time.
Professional-grade solution trusted by motorcycle builders and restorers worldwide.
