You may also like
Rigid lowering hardtail struts for your Honda Shadow replace your stock shocks and lower the rear of your Honda Shadow to give you the hardtail feel and look with zero fabrication! Easy to install and within minutes you can slam the rear of your bike to get that sexy low hardtailed look!
Fits the following models:
Specs:
Struts are installed with the stock hardware on your bike (bolts, washers).
Simply jack the rear wheel up enough to relieve the pressure on the shocks, remove the shocks and slide on the struts, replace the bolts and washers, you're ready to ride!
For the 750 shaft drive models, the metal bushings must be removed from shock ends (the rubber part isn't needed) and put into the struts mounting holes, it's super dang simple!
They can be pressed out by hand, but a socket and some vise grips will do the job in a pinch!
How much the struts will lower your bike will vary depending on model, tire size, tire inflation, wheel size, rake, etc.
To determine approximately how much these shocks will lower your bike, measure your shocks mounts center to center and subtract 9.5" That distance will be approximately how much the bike will be lowered.
TJ Brutal Honda Shadow Solid Handlebar Riser Bushings
Regular price $55.00These solid handlebar riser bushings fit all bikes with a 34mm riser pocket in the top tree. These will work with the stock Honda Shadow handlebar risers, as well as with aftermarket handlebar risers. In some cases if you drill out the stock metal bushings inside the Honda Shadow top clamp, you will be able to mount aftermarket handlebar risers or Harley risers in your top clamp!
Includes:
Some people may need the lower bushings some may not, enough people gave feedback that they would be helpful so we decided to make sure you have what you need!
These do not replace the stock rubber bushings that are permanently in your top tree, they replace the removable rubber bushings under the risers.
Please pull your risers off to make sure you have a 34mm pocket. some models of VT750 and VT1100, VTX and other shadows did not have this pocket.
ONLY ONE SET NEEDED TO STABILIZE YOUR RISERS
Your Honda Shadow stock top clamp has rubber riser bushings that get mushy over time and your bars can flex pretty bad. This leads to poor handling and a dangerous situation when you need to handle your bike quickly to avoid a collision. The solution to this is to use these solid riser bushings for a positive connection between bars and front suspension.
NOT NEEDED FOR HONDA SHADOW AERO YEARS 2005-2007
TJ Brutal Customs Shorty Choke Knob - Honda Shadow VT600, VLX & VT750 VT500
Regular price $64.99Replace the stock chock assembly with these Shorty Choke Knobs to clean up the look of your Honda Shadow.
Single Carb Choke Knob Will Fit:
Dual Carb Choke Knobs Will Fit:
You can pull firmly on the knob and they will lock into place, once locked open let the bike warm-up for a few minutes. To shut off the choke, Press it into its seated position.
These will fit the dual and single carb Honda VLX, VT600, and the single and dual carb VT750, as well as the VT1100 and VTX1300. If your stock air filter box is installed, accessing the choke will be near impossible. These are best paired with the TJ Brutal velocity stack intakes!
TJ Brutal Vacuum Plugs For Single and Dual Carb Shadows
Regular price $13.00If you want to remove all the extra hoses and unnecessary lines from your vacuum system, you need these plugs. Otherwise, your carbs will not work correctly.
NOTE- Not all carbs will need a vacuum plug set and some carbs will only use a part of the vacuum plug set.
TJ Brutal Customs Carb Intake Boot Replacement Kit
Regular price $32.56These boots are a common cause of issues on the Honda Shadow. Eventually, the rubber will dry out and form small cracks that can be hard to find. Causing issues with how the engine runs. You can spend a lot of time troubleshooting and searching for the issue before realizing that it is these boots. If you are removing your carbs and still have the original boots, we suggest changing them.
INSTALLATION TIP!
When installing your new intake boot, put a tiny bit of grease on your finger and apply a thin film to the inside surface of both ends of the carb boot and the carb flange. This makes installation a breeze and you won't be fighting friction!
Dual Carb Kit Will Fit:
1988-1989 VT600C SHADOW VLX 600
1991-1997 VT600C SHADOW VLX 600
1993-1998 VT600CD SHADOW VLX DELUXE
1998-2000 VT750C SHADOW ACE
1998-2001 VT750CD SHADOW ACE DELUXE
1998-2001 VT750CD2 SHADOW ACE DELUXE
2002-2003 VT750CDA SHADOW ACE DELUXE
2002-2003 VT750CDB SHADOW ACE DELUXE
2002-2003 VT750CDC SHADOW ACE DELUXE
2002-2003 VT750CDD SHADOW ACE DELUXE
2001-2002 VT750DC SHADOW SPIRIT 750
2003; 2005-2007 VT750DCA SHADOW SPIRIT 750
2003; 2005-2007 VT750DCB SHADOW SPIRIT 750
1989-1990 XL600V TRANSALP 600
SOLD AS A PAIR - YOU WILL RECEIVE 2 BOOTS WITH 4 CLAMPS
Single Carb Kit Will Fit:
TJ Brutal Customs 3L Lockable Jerry Can and Sissy Bar Mount - Black
Regular price $221.95TJ Brutal Customs has come up with arguably the best fuel solution we've seen yet! Perfect for long road trips or those small tank blues for daily riders rockin' a peanut tank.
Not only will it mount to frames, but it includes the TJBC proprietary sissy bar mount which allows you to mount your jerry can on the back of any sissy bar.